introduction
Vision V3 is normal capacity clearomizer which is improved and with long wicks just like V2. It is such a genuine beauty from Vision High Tech and design such way to compatible with most of eGo and eGo-T batteries. This Vision V3 is so famous due to easy filling and leakage free (recommended for new users). Vision produces huge vapor with quality taste very thick smoke like traditional Hookah’s smoke. It has standard resistance 2.4 ohm and low resistance 1.8 ohm. Filling it with injector will save you to waste liquid.
how to refill
Detach the drip tip and pour eliquid or inject from injector make sure not a small amount of liquid pours into metal tube by mistake because it is only for airflow.
Tight the drip tip back to its port and wait at least 2 minutes so, the coil absorb the liquid properly before you start smoking.
Tight the drip tip back to its port and wait at least 2 minutes so, the coil absorb the liquid properly before you start smoking.
how to use/ clean Vision eGo clearomizers.
When the level of e liquid is low in tank it can be still wicking due to long and improved wick in V3 version so you can enjoy long lasting smoking on one filling.
Cleaning of Vision V3 is quite easier whenever you feel the device is not producing that much and little bit change in taste (usually it will happen after one week) just unscrew the drip tip and wash inside everything with warm water and let it be DRY. Before using burn coil for 2 minutes in short bursts when you see it turn into red glow clean it again, finally add i.6ml liquid and screw the drip tip. Make sure during wash do not lose a silicon o ring it is placed to stop leaking liquid from the top of clearomizer.
Cleaning of Vision V3 is quite easier whenever you feel the device is not producing that much and little bit change in taste (usually it will happen after one week) just unscrew the drip tip and wash inside everything with warm water and let it be DRY. Before using burn coil for 2 minutes in short bursts when you see it turn into red glow clean it again, finally add i.6ml liquid and screw the drip tip. Make sure during wash do not lose a silicon o ring it is placed to stop leaking liquid from the top of clearomizer.